Endurance board, as a typical building material, is often used in the process of house decoration, but it is often wasted due to the unreasonable use of construction personnel, thus increasing the decoration cost to a certain extent. How to reduce the waste of endurance board? Shanghai Jienai Endurance Board Manufacturer Xiao Bian tells you. In the process of endurance board processing and construction, some constructors only want to earn more money, and they do not use the endurance board according to the standards, resulting in a waste of endurance board materials, which also leads to an increase in material costs. Although the waste of endurance boards at the construction site is unavoidable, it is also limited.
In general, the waste of PC endurance boards during construction can be controlled at 6% - 8%. If this value is exceeded, it may be caused by not following the normal operation methods. At this time, we must pay attention and inform the construction personnel to operate according to the formal process, so that we can save a lot of costs.
In addition to using the endurance board according to the normal process, in order to reduce waste, we can make rational use of the leftover materials of the endurance board cut. Normally, it can be used for future repair, and at the same time, we can also repair the damaged parts of the endurance board on some buildings slightly. At this time, we may need a small endurance board, which is convenient, economical and practical.
This will involve the preservation of endurance boards. It is very simple. As long as you are careful not to expose yourself to the sun, do not remove the protective film on the board surface if not used; If there is dust on the board surface, clean it with clean water. Normally, clean it with water below 50 ℃, but remember to use neutral detergent instead of acidic or alkaline detergent; After cleaning, rinse with clean water and then air dry.
